Example of a balancing cycle with the balancing processor ebm100:
The relationship between the angular scale direction and the spindle turning direction must be checked and set correctly. Use the “mode” key to change the settings. The current setting is indicated by the red LED to the right of the “mode” button. The following two settings are possible:
- Scale incrementing in the same direction as the spindle turning direction
- Scale incrementing counter to the spindle turning direction
Further information is found on this internet page under „Scale incrementing direction“
![]() |
» Step 1 (setup)
» Step 2 (reference measurement 1)
» Step 2 (reference measurement 2)
» Step 4 (balancing)
» Step 5 (rebalancing)